Sony CBK-3620XS Bedienungsanleitung Seite 18

Usage Precautions
• The camera must be updated to the
following software version or later to use
this unit.
MPC-3628/MPC-3626: V2.0 or later
MPC-3610: V6.3 or later
Disconnect the unit and reassemble the
camera to its normal state before
updating.
• The start up time may take longer when
starting for the first time after replacing
the imager block. Do not turn the unit off
until startup has finished.
• When this unit is connected to an 8K
imager block, it takes about 30 seconds
each time before the camera starts up.
• If the unit is suddenly taken from a cold to
a warm location, or if ambient
temperature suddenly rises, moisture
may form on the outer surface of the unit
and/or inside of the unit. This is known as
condensation. If condensation occurs,
turn off the unit and wait until the
condensation clears before operating the
unit. Operating the unit while
condensation is present may damage the
unit.
• The life expectancy of the electrolytic
capacitor is about 5 years under normal
operating temperatures and normal
usage (8 hours per day; 25 days per
month).
If usage exceeds the above normal usage
frequency, the life expectancy may be
reduced correspondingly.
• Using the unit with dirt or dust adhering
to the connector between the camera
body and sensor block may cause a
failure or malfunction. When storing, use
the supplied protection cap to prevent
dust from adhering to the connector.
18
Usage Precautions
To prevent electromagnetic interference
from portable communications devices
The use of portable telephones and other
communications devices near this unit can
result in malfunctions and interference
with audio and video signals.
It is recommended that the portable
communications devices near this unit be
powered off.