Sony CBK-3620XS Bedienungsanleitung Seite 21

The lamp is lit orange when the assigned
function is on (enabled) or activated.
For details about function assignment,
refer to the MPC-3628/MPC-3626/MPC-
3610 Operating Instructions.
 Tape measure hook attachment
hole
Hole for attaching a tape measure hook.
You can remove the tape measure hook
from the camera and attach it here.
 24 V OUT connector (Fischer 3-pin)
External power supply output connector.
It outputs the power supply connected to
the 24 V IN connector of the camera body
adaptor.
It can be connected as an external power
supply for a monitor or lens servo. It can
also be used to input a REC Trigger signal.
Notes
• Depending on the output current and the
length of the imager block adaptor, the voltage
of the power supply output from this connector
will be lower than the voltage of the power
supply connected to the 24 V IN connector.
– Imager block adaptor (3 m (9.8 ft)):
Approximately 0.25 V drop at 1 A output or
0.50 V drop at 2 A output
– Imager block adaptor (12 m (39.4 ft)):
Approximately 1.00 V drop at 1 A output or
2.00 V drop at 2 A output
• For details about Fischer 3-pin connector
specifications, refer to the MPC-3628/MPC-
3626/MPC-3610 Operating Instructions.
 MONITOR OUT connector (BNC
type)
Monitor signal output connector. Outputs
the video signal connected to the
MONITOR IN connector of the camera body
adaptor.
 ASSIGN (assignable) button 7
Toggles the assigned function between
on/off (enable/disable) or activates the
function with each press.
The LEDs at both ends of the imager block
adaptor are lit orange when the assigned
function is on (enabled) or activated.
For details about function assignment,
refer to the MPC-3628/MPC-3626/MPC-
3610 Operating Instructions.
 Imager block adaptor (12 m
(39.4 ft))
Adaptor (with extension cable) that
attaches to the imager block removed from
the camera.
Note
For details about accessory mounting holes, see
the external dimensions drawing at the back of
this document.
Location and Function of Parts
21