cecotec BOLERO DRESSCODE 8300 INVERTER MAX A Bedienungsanleitung Seite 45

ENGLISH
Usage counter
- Unplug the equipment for 10 seconds and plug it in again.
- Switch on the machine and wait for 10 seconds, press "Delay" and "Drum Clean" on the
control panel simultaneously and continuously for about 5 seconds until the display shows
digits, the value indicates the usage times of the machine.
- Repeat step 1 again to resume normal operation.
Tips for use
- After a programme is completed, wait for two minutes before opening the door.
- Check whether the water inside the drum has been drained before opening its door. Do not
open the door if there is any water.
Do not wash only one piece of clothes or garment, as these could cause great unbalance.
-
Always introduce at least 3 or 4 clothes so that draining can be done smoothly.
- The information given for the programmes different to the eco 40-60 programme are just
indicative.
The eco 40-60 programme can clean normally soiled cotton clothes declared as washable
-
at 40ºC or 60ºC, together in the same cycle. This programme is used to assess compliance
with EU eco-design legislation.
- The times indicated for each programme match the length with standard loads and
temperatures. Other loads and temperatures will need different programme length.
- The most efficient programmes in terms of energy consumption are generally those that
are carried out at lower temperatures and longer length.
- Load the washing machine to the quantity estimated for each programme, this will help
you save energy and water.
- The length, and energy and water consumption of each programme may vary according
to the weight and type of laundry, the additional functions active, water, and ambient
temperature.
It is recommended the use of liquid detergent for washing programmes at low temperature.
-
You can vary the quantity of detergent according to the quantity of laundry and its soiling
level. Follow the detergent manufacturer recommendations for the quantity of detergent
you must use.
You can find more information on this model by scanning the QR code of the reference of
-
your product (you will also find the energy label).
88
Bolero DressCode 8300_9300 Inverter Max A
Product Bolero DressCode 8300
Inverter Max A
Reference: 02792
QR code
5. CLEANING AND MAINTENANCE
Warning
- Before cleaning or repair tasks, unplug the appliance from the mains and close the water
tap.
- Proper maintenance on the washing machine can extend its working life. The surface can
be cleaned with diluted non-abrasive, neutral detergents if necessary. If there is any water
overflow, use a cloth to wipe it off immediately.
Do not use abrasive cleaners or scouring pads to clean the device.
-
Cleaning the drum
- The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
- Do not use steel wool.
Note
Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
- Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it can
cause leaks. Fig. 21
- Remove any coins, buttons and other objects from the seal after each wash.
Cleaning the inlet filter
Note
The inlet filter must be cleaned when there is little water.
Washing the tap filter. Fig. 22
1. Close the water supply tap.
2. Remove the water supply hose from the tap.
3. Clean the filter with a soft brush.
ENGLISH
Bolero DressCode 9300
Inverter Max A
02794
Bolero DressCode 8300_9300 Inverter Max A
89