Saeco Incanto HD8919 Bedienungsanleitung Seite 32

The drip tray is quickly
filled.
The coffee grounds
container full icon remains
displayed.
The brew group cannot be
removed.
The brew group cannot be
inserted.
The coffee has too little
cream or is watery.
This is normal. The machine uses
water to rinse the internal circuit and
brew group. Some water flows
through the internal system directly
into the drip tray.
The coffee grounds container was
emptied while the machine was
switched off.
The coffee grounds container was
placed back too fast.
The brew group is not positioned
correctly.
The coffee grounds container is not
removed.
The brew group is not in the correct
position.
The machine is still in the descaling
procedure.
The grinder is set to a coarse setting.
The coffee blend is not the correct
one.
English
Empty the drip tray when the 'drip
tray full' full indicator pops up
through the drip tray cover.
Place a cup under the dispensing
spout to collect rinsing water.
Always empty the coffee grounds
container while the machine is ON.
If the coffee grounds container is
emptied while the machine is
switched off, the coffee cycle
counter is not reset. In that case,
the 'empty coffee grounds
container' message will stay on the
display even though the container
is not full.
Do not place back the coffee
grounds container until the screen
message prompts you to put it
back
Close the maintenance door.
Switch the machine off and back
on again. Wait for the machine
ready screen to appear and then
remove the brew group
Remove the coffee grounds
container before removing the
brew group
The brew group was not put in rest
position before it was placed back.
Make sure that the lever is in
contact with the base of the brew
group and that the hook of the
brew group is in the correct
position.
Reset the machine by switching it
on and off. Place the drip tray and
the coffee grounds container back.
Leave the brew group out. Close
the maintenance door and switch
the machine on and off. Then try
to reinsert the brew group.
You cannot remove the brew
group when the descaling process
is active. 5irst complete the
descaling process and then
remove the brew group.
Adjust the grinder to a finer setting.
Change the coffee blend.