Restore Factory Settings; Maintenance And Cleaning - eQ-3 HomeMatic IP wired HmIPW-WRC6-A Installations- Und Bedienungsanleitung

Restore factory settings

8 Restore factory settings
The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the device, please pro-
ceed as follows:
• Press and hold down the system button (E) for 4
seconds until the LED (E) starts quickly flashing
orange (see fig. 9).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the LED lights up green (see fig-
ure 10).
• Release the system button to finish the procedure.
The device will perform a restart. After the restart, you can
again integrate your device into your system.
9

Maintenance and cleaning

The product does not require any maintenance.
Enlist the help of an expert to carry out any re-
pairs.
Clean the device using a soft, lint-free cloth that is clean
and dry. Do not use any detergents containing solvents,
as they could corrode the plastic housing and label.
48