Start-Up; Installation Instructions - eQ-3 HomeMatic IP wired HmIPW-WRC6-A Installations- Und Bedienungsanleitung

Start-up

5 Start-up
5.1

Installation instructions

Since the bus is powered by the Homematic IP
Wired Access Point (HmIPW-DRAP), you must
first set-up a Homematic IP Wired Access Point
(HmIPW-DRAP) to enable power supply for the
device.
Before installation, please note the device num-
ber (SGTIN) labelled on the device as well as the
exact application purpose in order to make later
allocation easier. You can also find the device
number on the QR code sticker supplied.
Please note the insulation stripping length of the
conductor to be connected, indicated on the device.
Please observe the hazard information in section
"2 Hazard information" on page 31 during in-
stallation.
Please note! Only to be installed by persons with
the relevant electro-technical knowledge and
experience!*
Incorrect installation can put
• your own life at risk;
• and the lives of other users of the electrical system.
36