Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
For the installation, please proceed as follows:
•
Disconnect the corresponding line of the incom-
ing Homematic IP wired bus.
•
Connect the Homematic IP wired bus to the bus
connecting terminals (see figure 3). To connect
and loosen the single wires, press the orange
clamp using a small screwdriver.
•
Place the mounting plate (A) in the flush-mount-
ed box and fasten it to the flush-mounted box us-
ing the screws supplied (see figure 4).
Place the supplied clip-on frame (B) or the frame
•
of your existing switch series on the mounting
plate (see figure 5+6).
•
Insert the desired labelling template into the la-
belling field (C) by removing transparent cover
and then replacing it.
Place the electronic unit (C) of the wall-mount
•
remote control into the frame by fully snapping
the connection pins into the appropriate bracket
of the mounting plate (see figure 5+6).
•
Switch the Homematic IP wired bus on again to
activate the teach-in mode of the device (see "5.4
Teaching-in" on page 40).
5.3
Installation in multiple combinations
You can mount the device with the attachment frame (B)
provided or use it with frames of other manufacturers as
well as integrate the electronic unit (C) into a multi-gang
Start-up
39
Werbung
Kapitel
Inhaltsverzeichnis
