Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
-
It is important to charge it when the battery is low. During charge, the battery indicator
will flash.
-
Once your upright vacuum cleaner is hanging on the wall bracket, connect the cord to a
power supply and let it charge.
-
To charge the battery separately, press the battery release button and separate it from the
main body. Place it on a flat and safe surface and connect it to the power supply.
-
Disconnect the device or the battery from the power socket when the battery indicator is
steady red.
Note
Unplug the device from the electric circuit if you are going to remove the battery from the
vacuum cleaner.
5. CLEANING AND MAINTENANCE
-
Turn the appliance off, unplug it from the power supply and allow it to cool down before
cleaning it.
-
Use a soft, slightly dampened cloth to clean the device's surface.
-
Never immerse the device in water or other liquids, do not allow liquids to enter the device.
-
Do not use sponges, powder products or abrasive cleaning agents to clean the product.
-
Do not leave the device in a place with direct sunlight.
-
Do not leave the device in a wet place after cleaning it.
Emptying the dust tank. Fig. 9
-
Place the dust tank from the main body over a bin.
-
Push the black tab located on the lower part of the dust tank until the cover opens.
-
Then, dust will fall off, so you must secure the tank is in the bin position.
Filter cleaning and maintenance. Fig. 10
-
It is recommended to clean the filters regularly to ensure maximum efficiency.
-
Pull the dust tank release trigger and separate the dust tank from the upright vacuum
cleaner.
-
Remove the primary filter and the pre-filter assembly.
-
Disassemble the pre-filter assembly by turning the mesh filter clockwise and pulling.
-
Vacuum and shake the filters to remove every particle and dust remain that may block
them and difficult the correct air circulation. Remember not to use the vacuum cleaner
without the filters properly assembled.
-
Do not brush the filters.
Cleaning the brushes
54
It is important to clean the brushes regularly to avoid hair and other foreign objects from
tangling and to prevent blockages. Fig. 11
Fig. 12
-
Press the brush release button on the bottom part of the brush head and remove the brush.
-
Remove the brush side tab.
-
Remove the Jalisco brush from the vacuum cleaner brush head.
-
In order to avoid any damages in the brush, hair can be cut and removed if it is wrapped
around both sides of the Jalisco brush.
-
You can clean the Jalisco brush with warm water, do not use soap or detergents. However,
it is recommended to shake it or vacuum it to avoid placing it back again wet in the brush
head.
-
If you decide to wash the Jalisco brush, make sure it is completely dry before installing it
again on the device.
-
Make sure it is properly installed, otherwise the brush will not start operating.
6. TROUBLESHOOTING
Problem
Cause
The device does not work.
There is no battery in the
device.
The battery is old.
Abnormal operation of the
motor.
The device does not
One of the filters is
vacuum or loses suction
blocked.
power.
The dust tank is full.
The dust tank is not
installed correctly.
The Jalisco brush is
blocked.
The battery does not
The charger is not
charge.
correctly connected.
The rotating brush stops
The filter has been used
working suddenly.
for a long period of time.
The filter is blocked.
ENGLISH
Solution
Charge the battery.
Buy a new battery or replace it.
Contact the official Technical
Support Service of Cecotec to
repair it.
Wash the filter and dry it before
use.
Clean the dust tank.
Install the dust tank correctly.
Clean the Jalisco brush.
Check the connections.
Check the power socket.
Replace the filter.
Clean the rotating brush.
CONGA ROCKSTAR 990 TITANIUM ERGOFLEX
55
Werbung
