cecotec CONGA PERFECT&CLEAN CONNECTED VITAL Bedienungsanleitung Seite 45

It is recommended to replace the high-efficiency filter with a new one without exceeding 160
cleaning hours.
Recommendation
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a primary mesh filter and a sponge filter, located next to
the high-efficiency filter. It is suggested to replace them either after a maximum of 160 hours
of use or when they are worn out due to operation.
Recommendation
Dirt can be removed with a small brush or by shaking carefully against a hard surface for dust
to fall off. You can also use warm water without detergents to obtain better results. Always
make sure they are completely dry before installing them again; otherwise, moisture can reach
the robot motor and damage it.
Free-fall sensors cleaning
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
robot lower part.
Warning
Do not apply cleaning products directly on the sensors.
Cleaning the silicone brush
1. Slightly press the silicone brush frame tabs in order to open the slot and remove it. Fig. 27
2. Remove any hair, lint or other dirt trapped in the brush and around the shafts.
3. Clear and clean the robot suction channel. Fig. 28
4. Reinstall the silicone brush and its frame.
Recommendation
It is recommended to clean the silicone brush once a week with the help of the autoclean brush.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to thoroughly clean edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. For this reason, it is suggested to replace each
side brush after a maximum of 220 hours or less.
ENGLISH
45