Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLESHOOTING
CAUTION!
Before troubleshooting, disconnect the appliance from the power supply. Any
troubleshooting procedures not listed in this manual should only be carried out by a qualified
electrician or competent person.
IMPORTANT NOTE!
circuit).
Problem
The appliance is
not working.
The appliance
freezes or cools
excessively.
The food is not
sufficiently
frozen.
There is a lot of
frost on the door
seal.
Some noises can be heard during normal operation (compressor, refrigerant
Possible cause
1. The power plug is not
plugged in or is loose.
2. The fuse has blown or is
defective.
3. The socket is defective.
The temperature is set too
cold or the appliance is
operating in SUPER mode.
1. The temperature is not
set correctly.
2. The door has been open
for a long time.
3. A large amount of hot
food has been placed in
the appliance within the
last 24 hours.
4. The appliance is located
near a source of heat.
The door seal is not airtight.
Solution
1. Insert the power plug.
2. Check the fuse and replace it if
necessary.
3. Faults in the power supply must
be repaired by an electrician.
Temporarily turn the temperature
control to a warmer setting.
1. Please refer to the section on
initial temperature settings.
2. Open the door only as long as
necessary.
3. Temporarily turn the
temperature control to a colder
setting.
4. Please refer to the section on
the place of installation.
Carefully heat the non-airtight areas
of the door seal with a hair dryer
(on a cool setting). As you do this,
shape the heated door seal by
hand so that it fits properly.
24
Werbung
