Denzel DS-4516 Benutzeranleitung Seite 7

GASOLINE CHAIN SAW
7
and should never be done. NOTE: For chain saws, designed with the guide bar on the left side, the
reference to "right hand"and "left hand"positioning is reserved.
Do not operate the chainsaw with one hand! Serious injuries to the operator, assistants and others can
result from operation with one hand. The chainsaw is designed for two-handed operation. Start work
only after freeing the work area from unnecessary objects.
Before starting the device, make sure that the chain is not in contact with anything.
During saw transportation, the motor must be turned off with the bar and chain facing back. When
carrying the chainsaw, always place the cover on the bar.
WARNING: Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent
accidental starting when setting up, transporting, adjusting or making repairs except carburetor adjustments.
This chain saw for forest service is only designed for cutting wood. Because a chain saw is a high-speed
wood-cutting tool, special safety precautions must be observed to reduce the risk of accidents. Careless
or improper use of this tool can cause serious injury.
Handle fuel with caution
– Do not smoke while handling fuel or while operating the saw.
– Eliminate all sources of sparks or flame in the areas where fuel is mixed or poured.
There should be no smoking, openflames, or work that could cause sparks. Allow engine to cool before
refueling.
– Mix and pour fuel in an outdoor area on bare ground; store fuel in a cool, dry, well ventilated place; and
use an approved, marked container for all fuel purposes.
Wipe up all fuel spills before starting saw.
– Move at least 10 feet (3 meters) from fueling site before starting engine.
– Turn the engine off and let saw cool in a non-combustible area, not on dry leaves, straw, paper, etc.
Slowly remove fuel cap and refuel unit.
– Storethe unit and fuel in an area where fuel vapors cannot reach sparks or open flames from water
heaters, electric motors or switches, furnaces, etc.
Be especially careful when trimming bushes and seedlings, as their elastic branches can fall into a chain, hit
or unbalance you. When cutting a branch that is exposed to external load, beware of the impact after removing
the load. Before sawing, check the wood for foreign objects such as nails. Be sure to remove them before cutting.
Use the device only for its intended purpose. The saw is intended for cutting wood only. Do not use the
saw for other purposes not specified herein. For example cutting plastics, masonry, etc. Before work,
clean and wipe the handles.
Do not cut above shoulder level, bend over too much and touch the ground with a saw chain. When
sawing boards and logs, it is necessary to use a reliable stand (framing). Do not let the other person hold
the log while sawing and never hold the log with your foot.
Do not work in low light conditions and on steep slopes.
The saw should be guided in such a way that no part of the body is in the cutting plane (Fig. 1).
Fig. 1
National regulation can restrict the use of the product.