Denzel DS-4516 Benutzeranleitung Seite 15

GASOLINE CHAIN SAW
Chain saw oil changing
WARNING!
Never use used oil! Waste oil is harmful to the environment and may result in damage.
Chain saw oil should be used to lubricate the saw chain and bar. Use oil that contains additives to reduce
friction and wear and to prevent resin build-up on the bar and chain.
WARNING!
Before filling the oil tank, make sure that the chainsaw is turned off.
To fill the oil tank:
1. Be sure to clean the surface around the oil tank cap to prevent dirt from getting inside.
2. Unscrew the oil tank cap and pour in the chain saw oil (260 ml tank capacity).
3. Screw the oil tank cap back on.
4. Before you start, check the oil supply: switch on the chainsaw and hold it over suitable bedding.
If it is sufficiently lubricated, a light trail of dripping oil will form (fig. 13).
WARNING!
Always check the oil level. Do not operate the chain saw if there is insufficient oil to lubricate the
chain.
Proper lubrication is essential to reduce chain and bar friction. Operating a chain saw with insufficient
lubrication reduces performance and service life and causes fast chain and bar wear due to overheating.
This chainsaw is equipped with an automatic lubrication system that provides the necessary amount
of lubrication to the bar and chain. As the engine speed increases so does the oil supply to the bar.
Chainsaw fuel mix
For best results use standard quality AI-92 gasoline without additives mixed with special oil for 2-stroke
engines in the proportion indicated on the oil package. The recommended mixing ratio is 1:40, unless this
differs from the oil manufacturer's recommendation. Mix fuel and 2-stroke oil in a special container until
a homogeneous mixture is obtained.
WARNING!
Do not fill your chainsaw with pure gasoline. This will cause the engine to malfunction and will
void the manufacturer's warranty on the product.
It is not recommended to use a fuel mixture that has been stored for more than 30 days.
Fig. 13
15