Werbung
Verfügbare Sprachen
Verfügbare Sprachen
22
Carburettor adjustment
The carburettor is factory set for optimum performance. If adjustments are necessary, contact your nearest
authorized service center.
Preservation of the chain saw
When storing the chain saw for more than 30 days, you must preserve it. If preservation instructions are not
followed, the fuel remaining in the carburetor will evaporate, leaving a viscous, jelly-like residue. This will
cause engine start-up problems and costly repairs.
WARNING!
Do not store the chainsaw for more than 30 days unless the following measures have been taken:
1. Carefully open the fuel filler cap so that any excess pressure that may be present in the fuel tank is slowly
released. Drain any remaining fuel.
2. Start the engine and run it until it stops to allow the carburettor to evaporate.
3. Allow the engine to cool (about 5 minutes).
4. Use a spark plug wrench to remove the spark plug.
5. Add 1 teaspoon of pure 2-stroke oil to the spark plug hole. Pull the starter cord slowly several times to coat
the internal components with oil. Reinsert the spark plug.
NOTE: Store the chainsaw in a dry place, away from possible sources of fire, such as stoves, gas heaters, etc.
Preparing the machine for use after preservation
1. Remove the spark plug.
2. Retrieve the starter cord with a forceful pull to bleed excess oil from the fuel tank. 3.
3. Clean and adjust the spark plug gap or insert a new spark plug with the proper gap.
4. Prepare the chainsaw for operation.
5. Fill the tank with a suitable fuel mix of gasoline and oil.
Cleaning the tool
WARNING!
Do not use water or other liquids for cleaning! Be careful when cleaning the tool. Always wear
protective gloves.
Turn off the machine. Wait approximately 10-15 minutes for the engine to cool completely. Wipe all surfaces
and vents with a dry cloth or rag and use a special brush if necessary.
To ensure proper operation of the oil pump, periodically clean the oil groove and the oil inlet in the guide
bar of the saw.
1
Fig. 26
0,7-0,8 mm
2
Fig. 27
GASOLINE CHAIN SAW
Werbung
