Philips HI 980 Bedienungsanleitung Seite 6

- Remove the mains
plug from the wall
socket.
- Carefully unscrew the
cap of the steam tank
(anti-clockwise) until
you can hear steam
escaping (fig. 6).
Wait for the hissing
sound to stop.
This high-pitched sound is completely normal
and is not dangerous.
- Carefully unscrew the cap of the steam tank
further, until you hear the hissing sound again.
Wait again until the sound stops. Proceed in the
same manner until the cap is unscrewed.
- Wait for a few minutes. Then slowly pour
water into the filling opening (E) (fig. 2).
- Close the steam tank by turning the screw cap
manually (clockwise) until tight (fig. 3).
Steam-ironing
• As indicated on the temperature dial (I) and the
table, steam-ironing is only possible at higher
ironing temperatures, so set the dial to 2 or
3 .
- Insert the mains plug into a wall socket.
7
- Set switch "Steam tank on/off" ≤ (B) to
position |. The pilot light in the switch as well as
pilot light "Steam tank heating up U (C) will
come on (fig. 7).
• The iron heats up faster than the steam tank.
Hence you can switch on the iron a few minutes
later than the steam tank.
- Select the required
ironing temperature
with the temperature
dial (I) (fig. 8).
- Set switch "Iron
on/off" ≥(D) to
position |.
The pilot light in the
switch as well as
pilot light "Iron
heating up" (H) will
come on (fig. 9)
6
FILLING OPENING
WITH SCREW CAP
8
9
- After a few minutes, pilot light "Iron heating up"
(H) will go out. This indicates that the soleplate
has reached the set temperature.
- When pilot light "Steam tank heating up U (C)
goes out, this indicates that the steam tank is
heated up and that steam is ready.
You can now start steam ironing.
- While steam-ironing
keep the steam
activator (G) pressed-
in (fig. 10).
• During steam-ironing
the two pilot lights (C)
and (H) will come on
from time to time.
When this happens,
either the iron or the
steam tank is being heated-up to the required
temperature. You can continue ironing.
Steaming in a vertical position
Hanging curtains and
clothing (jackets,
woman's suits, coats)
can be steamed by
holding the iron in a
vertical position (fig. 11).
Dry-ironing
• For ironing without steam, do not press-in the
steam activator (G).
• You may switch off the steam tank by setting
switch "Steam tank on/off" ≤ (B) to
position O.
When finished ironing
12
- Switch off the steam tank and the iron
(fig. 12, 13).
- Remove the mains plug from the wall socket.
- Place the iron on the stand and let it cool down.
• It is not necessary to pour the remainder of the
water out of the steam tank.
6
10
11
13