EKOM DK50 2V/50/M Benutzerhandbuch Seite 44

Fig. 21: DK50 2x2V/110S/M cabinet clamps
 Connect the earthing conductor to the door and install the door on the cabinet and secure with
4 screws.
14. COMMISSIONING
 Make sure all transport stabilizers were removed.
 Check that all compressed air hose connections are correct (see chap. 11).
 Check correct connection to the mains (see chap. 12).
 Check the circuit breaker position, it must be in the "I" position. If the main switch (2) is in the
"0" position, turn it to the "I" position.(Fig. 22).
 For cabinet-mounted compressors, turn the main switch (4) on the front side of the cabinet into
the "I" position; a green indicator indicates the equipment is in operation. (Fig. 22).
 Check connection of the cabinet connector to the compressor (Fig. 13).
 Check connection of the cabinet manometer hose to the pneumatic block of the compressor
(Fig. 9).
 Check to ensure the hose from the automatic condensate drain is connected to the collection
vessel (Obr. 10).
 Configuring the language on the dryer display (see chap. 19.2)
 Configuring the date and time on the dryer display (see chap. 19.3)
 Check the drying mode settings (see chap. 19.4)
The compressor is not equipped with a backup power supply.
NP-DK50 2V 50, 2x2V 110-AD-A-2_05-2022 44
INSTALLATION
05/2022