Bosch Junkers DT 10 Bedienungsanleitung Seite 12

DT 10/DT 20
Safety precautions
These instructions must be
B
observed to ensure correct opera-
tion.
This accessory item should only be
B
installed by an approved installer.
Never connect this accessory item
B
to the 230 V mains electricity sup-
ply.
Isolate the mains electricity supply
B
before starting any work.
1 Technical data
for the accessory
item
• Accessory item may only be fitted in
appliances with Heatronic 3
• Can be combined with a controller
without its own timer
• DT 10: single channel with seven-
day program and three timed peri-
ods each day (channel allocation:
heating or hot water via
Heatronic 3)
• DT 20: two channels for heating
and hot water
day programs with three timed peri-
ods per day)
12
Technical data
Dimensions HxWxD
Rated voltage
Rated current
Ambient temperature 0 ... +50 °C
Display
Class of protection
Safety rating
2
B
B
(two seven-
Installation
Danger:
risk of electric shock!
Before installing, dis-
B
connect the mains
electricity supply
(230 V AC).
For a detailed description of the
parts of the appliance, see the
installation manual for the heater.
Connect and install the accessory
item as shown in Figures 2 to 5 on
page 103.
6 720 611 791 (2007/05)
120x133x27 mm
24 V DC
30 mA
24-hour;
illuminated
II
IP 24