Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
8. Install the remaining 4 angle bars of the required overall length as an
extension to the already mounted angle bars. The overlap A (Fig. 5)
must be at least 10 cm and joined with 4 screws. Use the ea.16 M4 X
10 mm screws with nuts and washers.
9. Push the inner shaft A (Fig. 6) (chimney shaft with the smaller
diameter) with screw holes B (Fig. 6) upwards, over the angle bar
construction and over the edge of the mounting plate D (Fig. 6). Make
sure that the screw holes B line up with holes C (Fig. 6).
Then screw mount the inner shaft securely to the mounting plate A
(Fig. 2) with four 8 mm flat-head self-tapping screws.
10.
Push the outer shaft A (Fig. 7) right up over the already screw
mounted inner shaft and fix with 2 S-hooks B (Fig. 7) in order that the
bottom part of the angle bar construction is accessible for the
subsequent mounting steps.
11.
Mount the exhaust air connector A (Fig. 8) with ea. 4 8 mm flat-
head screws on the motor housing B (Fig. 8).
If the hood is fitted with a top glass screen, push this over the motor
housing from above so that the holes in the glass screen line up with
the screw holes C (Fig. 8) in the hood. Then fix the glass screen to the
hood with 4 screws.
12.
Push the assembled hood into the angle bar construction and fix
it there with ea. 16 M4 screws (Fig. 9)
13.
Mount the exhaust air hose A (Fig. 10) to the exhaust air
connector on the hood B (Fig. 10).
14.
Raise the outer shaft C (Fig. 10) slightly, remove the 3 S-hooks D
(Fig. 10) and allow it to slide down on to the hood) see Fig. 11)
15.
Installing the glass screen A (Fig. 12)
Install the glass plate last of all.
Fix the glass screen with mounting screws B (Fig. 12)
Fig. 11
The figures are for illustration purpose only. The shape and composition of your hood can differ.
fi191220tnm
17. Installation Instructions for Island Cooker Hood
(where applicable)
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 12
A
12
D
A
A
B
C
B
GB
C
B
B
A
C
D
A
B
Werbung
