Stiga 100 Combi 3 EL QF Gebrauchsanweisung Seite 101

WARNING!: READ THE INSTRUCTION BOOKLET THOROUGHLY
EN
BEFORE USING THE MACHINE. Keep for future reference.
INDEX
1. GENERAL INFORMATION ........................... 1
2. SAFETY REGULATIONS .............................. 2
2.4 Maintenance, storage and transport...... 3
3. GETTING TO KNOW THE MACHINE ........... 3
3.1 Description of the machine and planned
use ........................................................ 3
3.2 Safety signs .......................................... 4
3.3 Identification label ................................ 4
3.4 Main components ................................. 4
4. ASSEMBLY ................................................... 4
4.1 Unpacking ............................................. 5
4.2 Connecting the cutting-means assembly
to the ride-on mower ............................. 5
4.3 Releasing the cutting-means assembly
from the ride-on mower ......................... 6
5. CONTROLS.................................................. 6
5.1 Cutting height adjustment ..................... 6
5.2 "Quick Flip" knobs ................................. 6
5.3 "Quick Flip" release levers ..................... 6
6. USING THE MACHINE ................................. 7
6.1 Preliminary procedures ......................... 7
6.2 Safety checks ........................................ 7
6.3 Start-up / working .................................. 7
6.4 After operation ...................................... 7
7. ROUTINE MAINTENANCE .......................... 7
7.1 General information ............................... 7
7.2 Wash and maintenance position ........... 7
7.3 Nuts and bolts ....................................... 8
7.4 Cleaning ................................................ 8
7.5 Lubrication ............................................ 8
8. OCCASIONAL MAINTENANCE ................... 8
8.1 Checking and replacing the cutting-
means ................................................... 8
8.2 Checking and replacing the cutting-
means transmission belt ....................... 9
8.3 Anti-wear guards ................................... 9
9. STORING ..................................................... 9
10. A SSISTANCE AND REPAIRS ....................... 9
11. H ANDLING AND TRANSPORTATION ......... 9
12. W ARRANTY COVERAGE ............................ 9
13. M AINTENANCE TABLE .............................. 10
14. PROBLEM IDENTIFICATION .................... 10
1. GENERAL INFORMATION
1.1 HOW TO READ THE MANUAL
Some paragraphs in the manual contain
important information regarding safety and
operation and are emphasized in this manner:
NOTE or IMPORTANT these give details
or further information on what has already been
said, and aim to prevent damage to the machine.
The symbol highlights danger. Failure to
observe the warning can lead to the risk of
injury to oneself and others and/or damage.
The paragraphs highlighted in a square with
grey spots indicate the optional characteristics
not on all models documented in this manual.
Check if the characteristic is on this model.
Whenever reference is made to a position
on the machine "front", "back", "left"
or "right" hand side, this is determined
from where the operator is driving.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for
use are numbered 1, 2, 3, etc.
The components indicated in the figures are
identified with letters A, B, C, and so on.
Reference to component C in figure
2 is indicated with the wording: "See
fig. 2.C" or simply "(Fig. 2.C)".
The figures are given as a guide only.
The actual pieces can differ from
those illustrated in this document.
1.2.2 Titles
The manual is divided into chapters and
paragraphs. The title of paragraph "2.1 Training"
is a subtitle of "2. Safety regulations". References
to titles or paragraphs are marked with the
abbreviation chap. or par. and the relevant
number. Example: "chap. 2" or "par. 2.1".
EN - 1