SoFlow SO2 ZERO Originalbetriebsanleitung Seite 20

5 Driving instructions
5.1 Operation
First switch on your SO2 ZERO by pressing the start button for 2 seconds. You can turn off your SO2 ZERO again by pressing and holding the
same button for a few seconds. If you press the start button only briefly, you will turn off the front light, which is turned on by default. By
pressing the button briefly and repeatedly, you switch the light back on.
Before starting your journey, make sure that the handlebars click into place.
First, switch on your SO2 ZERO by pressing and holding the power button for 2 seconds. You start your SO2 ZERO by using one leg to accelerate
yourself and the device by pushing your foot off the ground (like a conventional scooter). Now you can accelerate by pulling the throttle on
the right side of the handlebar.
You can operate the front electronic brake and the rear drum brake by using the brake lever on the left side of the handlebars. Shift your body
weight slightly to the rear to compensate for the braking effect of the brake. This allows safe and controlled braking. Always be careful when
using the brake. Pull the brake lever firmly to stop SO2 ZERO completely.
5.2 Display
You will find the following information on the display:
Light
•
Speed
•
Bluethooth
•
• Drive modus: Eco, Normal, Sport
• Km/h and mph
• Locked Mode
copyright by www.soflow.com 20