EFBE-SCHOTT WK 810 Gebrauchsanweisung Seite 10

Fax +32 2 359 95 50
(*) Competent qualified electrician: after-sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In case of need you should return the appliance to this electrician.
Positioning and connecting
• To avoid accidents and damages, always put the appliance on a level, dry and slip-proof
surface which is insensitive to heat and water splashes.
• Never put the appliance on a hotplate or close to a hot oven.
• Connect the appliance only to a wall socket that has been installed according to
regulations. Check that your mains voltage corresponds to the technical data of the
appliance. If necessary, use a proper extension cord, and make sure the technical data
correspond to those of the appliance.
• Your appliance must never be switched on through an external timer or any kind of separate
remote control system, or be connected with an electric circuit that is switched on and off
regularly by a device.
• The electric water jug can only be used with the foreseen support.
• Make sure the cord cannot get caught in any way. Make sure the cord never comes into
contact with the hot parts of the appliance. Make sure the cord never comes into contact
with moisture or humidity to avoid danger of electrocution.
• To ensure a major security, it is recommended to set up a current flight jump of 30 mA in the
electric circuit that supplies the household. Ask your electrician for advice.
Before the first use
• Remove all packaging material and protective foils.
• Before boiling water with the appliance for the first time, we recommend cleaning the
appliance by boiling water several times and rinsing the appliance afterwards.
Use
• Never leave the appliance unsupervised when in use.
• To fill the jug with water always remove it from the base station. Make sure that no water runs
down the appliance on the outside, it could penetrate into the inner part of the appliance
and damage the electric parts.
• Please note: Do not operate the electric water jug with too much or too little water. The
water level must always be between the MIN and MAX marks on the water level scale.
When you overfill the appliance, there is a risk of burning because of overflowing or spouting
boiling water.
• Watch out! Danger of burning! The appliance becomes very hot during use! In order to avoid
risks of burning, use the thermally insulated slider on the lid to open and close the lid. Never
touch the hot lid or housing. Be careful as very hot steam escapes when the water is boiling!
• During the operation of electrical heating appliances, high temperatures arise – due to
boiling water, hot steam and a hot housing and lid – which may lead to injuries. Take the hot
electric water jug by its handle only. As long as the appliance is in operation and boils water,
do not open the lid in order to avoid scalding!
• Caution! Never heat the appliance without water or with an open lid! Otherwise there is a
danger of overheating and escape of hot steam.
• When the appliance is in operation, there should be no materials that are sensitive to heat or
steam in the immediate surroundings! Keep a sufficient safety distance to walls, furniture,
etc.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
10
Assembly page 10/16
WK 810 - 101220