Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USING THE APPLIANCE FOR THE FIRST TIME
1.
SETTING THE TIME
You will need to set the time when you switch on the
appliance for the first time: "AUTO" and "0.00" flash on
the display.
A
U
T
O
To set the time of day, press buttons
same time: Set the time of day using the
buttons.
Please note: To change the time of the day afterwards for
example following lengthy power outages, you will need to
reset the time.
2.
SETTING THE TONE
Having selected the desired time value, press the time
button: The display shows "ton 1".
A
U
T
O
To select the desired tone, press button
the time button to confirm.
DAILY USE
1.
SELECT A FUNCTION
To select a function, turn the selection knob to the
symbol for the function you require.
2.
ACTIVATE A FUNCTION
To start the function you have selected, turn the
thermostat knob to set the temperature you require.
To interrupt the function at any time, switch off the
oven, turn the selection knob and the thermostat knob
to
and
.
3.
PREHEATING
Once the function has been activated, the LED
thermostat will switch on signalling that the
preheating process has begun.
At the end of this process, the LED thermostat
switches off indicating that the oven has reached the
set temperature: at this point, place the food inside
and proceed with cooking.
Please note: Placing the food in the oven before preheating
has finished may have an adverse effect on the final cooking
result.
3.
HEAT THE OVEN
A new oven may release odours that have been left
behind during manufacturing: this is completely
normal. Before starting to cook food, we therefore
recommend heating the oven with it empty in order
to remove any possible odours.
Remove any protective cardboard or transparent
film from the oven and remove any accessories from
inside it. Heat the oven to 250 °C for about one hour,
preferably using the "Convection Bake" function. The
and
at the
oven must be empty during this time.
and
Follow the instructions for setting the function
correctly.
Please note: It is advisable to air the room after using the
appliance for the first time.
, then press
. PROGRAMMING COOKING
After selecting and activating the function, it is
possible to set the duration.
Press the time button: the
A
U
T
O
Press the time button again: the display shows DUR
and AUTO flashes.
A
U
T
O
Set the duration using the buttons
few seconds, the display shows the time of the day
while AUTO remain lit, confirming the setting.
A
U
T
O
To view the remaining cooking duration press the
time button for at least 2 seconds.
To change it, if necessary, press it again a second time,
using
At the end of cooking, the symbol
alarm sounds while AUTO flashes on the display.
DURATION
and
buttons to modify the duration.
EN
symbol flashes.
and
. After a
switches off, an
3
Werbung
