Werbung
Verfügbare Sprachen
Verfügbare Sprachen
300 SERIES
U s e r m a n u a l
Mounting the loudspeaker
300 Series products include a mounting frame, a loudspeaker and both circular and square magnetic grilles. No tools are
required to mount the loudspeakers of the 300 Series range.
1. Pivot the mounting bracket until it clips onto the mounting frame so that the mounting frame can be pushed through the
opening (fig. 1).
2. With one hand, insert the mounting frame into the opening in the ceiling/wall, making sure it rests flush against the ceiling/
wall (fig. 2).
3. To fasten the mounting frame to the ceiling/wall, insert your other hand into the opening, and use two fingers to pivot the
mounting bracket to the opposite side to its initial position (fig. 3)
4. Push the mounting bracket down until it reaches the stop (fig. 4).
5. Finally, release the mounting bracket making sure it is securely in place. Also make sure the mounting bracket isn't resting
on the loudspeaker cable (fig. 5).
Note 1: repeat the operation for the other mounting brackets.
Note 2: to unlock the mounting bracket: use two fingers to pivot the mounting bracket towards the outside, pull upwards
and release.
6. Connect the previously stripped loudspeaker wires to the spring loaded terminals on the loudspeaker. It is
essential to connect the loudspeakers respecting the correct polarity: the cable connected to the "+" terminal on the
amplifier must be connected to the red terminal on the loudspeaker. Likewise, the cable connected to the "-" terminal on
the amplifier must be connected to the black terminal on the loudspeaker. Stereo image and bass perception would be
seriously compromised if these conditions were not respected (fig. 6).
7. The loudspeakers are now ready to be assembled to the mounting frame. In order to do this, position the red arrows on the
loudspeaker in line with the open padlocks on the mounting frame (fig. 8).
Note: if you plan to use your product as in-ceiling loudspeakers, the loudspeaker can be securely fastened to the ceiling using
a safety sling (not supplied) which fastens to the hook on the rear of the product (fig. 6).
8. Insert the loudspeaker into the mounting frame (fig. 7) until the stop, then pivot the loudspeaker using the red handles so
that the markers are positioned between two open padlocks (fig. 9).
9. The circular or square grilles can now be mounted to the loudspeaker. The grille is held to the mounting frame magnetically,
all you need to do is simply line them up (fig. 10).
10. 300 ICA6 loudspeakers have a red positioning arrow on their mounting frame. This arrow is used to point to the final
listening position when installing the product (fig. 11).
14
Werbung
