Troubleshooting; Errorcode - capital sports Pacemaker X60 Bedienungsanleitung

This treadmill is designed in a way that in the event of an electrical fault, the machine will turn off auto-
matically to prevent any injuries to the user and to prevent damage to the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power switch off, waiting
for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-checking analyse
(please refer to Self-Checking) to distinguish what type of error problem the machine is encountering.

Errorcode

No indication to safety key signal
E0
Correctly insert the safety key.
Over resistance or over load
E2
Put lubrication on running deck.
Motor burnt or demagnetization motor
E4
Correctly connect motor wire or replace motor.
Console wire unreliable connection
E5
Replace console wire.
Invalid hardware of MCB
E6
Replace MCB
Power supply
Check if the supply voltage is in the range of the working voltage or no
E7
Incline VR error
ERR
Check the incline cable and self-inspect again.

Troubleshooting

Cause and Solution
AC110V：AC90V~AC130V
AC220V：AC180V~AC250V
47