Intended Use - Gardena THS 500/48 Betriebsanleitung

en Telescopic Hedge Trimmer
1. SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
2. ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
3. OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
4. MAINTENANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
5. STORAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
6. TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
7. TECHNICAL DATA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
8. ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
9. SERVICE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
10. DISPOSAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Original instructions.
This product is not intended for use by persons (including chil-
dren) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the product by a person
responsible for their safety. Children should be supervised to ensure that
they do not play with the product.

Intended use:

This GARDENA Telescopic Hedge Trimmer is used to cut hedges,
shrubs and grass coverings in private domestic gardens and allotments.
DANGER! Risk of injury!
v Do not use the unit to cut lawns / lawn edges, to chop up
material or to make compost.
1. SAFETY
IMPORTANT!
Read the operator's manual carefully before use and keep for future
reference.
If not used properly this product can be dangerous. The warn-
ings and safety instructions must be followed to ensure reason-
able safety and efficiency in using this product. The operator is
responsible for following the warnings and instructions in this manual
and on the product. Never use the product unless the guards provided by
the manufacturer are in the correct position.
Symbols on the product:
Read operator's manual.
Wear safety glasses and ear protection.
Danger – Keep hands away from blade.
Do not let the unit become wet with rain or other moisture.
Do not leave the unit outdoors while it is raining.
Disconnect the mains cable if the cable becomes damaged
or cut.
Risk of fatal injury due to electric shock!
Keep at least 10 m away from electricity lines.
General safety warnings
General machine safety warnings
WARNING!
Read all safety warnings, instructions, illustrations and specifications
provided with this machine. Failure to follow the warnings and instructions may
result in electric shock, fire and / or serious injury.
Save all warnings and instructions for future reference.
The term "machine" in the warnings refers to your mains operated (corded)
machine or battery operated (cordless) machine.
8
8883-20.960.05.indd 8 8883-20.960.05.indd 8
1) Work area safety
a) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
b) Do not operate machines in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust.
Machines create sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a machine.
Distractions can cause you to lose control.
2) Electrical safety
a) Machine plugs must match the outlet. Never modify the plug in any
way. Do not use any adaptor plugs with earthed (grounded) machines.
Unmodified plugs and matching outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
c) Do not expose machines to rain or wet conditions.
Water entering a machine will increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or
unplugging the machine. Keep cord away from heat, oil, sharp edges
or moving parts.
Damaged or entangled cords increase the risk of electric shock.
e) When operating a machine outdoors, use an extension cord suitable
for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric shock.
f) If operating a machine in a damp location is unavoidable, use
a residual current device (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
3) Personal safety
a) Stay alert, watch what you are doing and use common sense when
operating a machine. Do not use a machine while you are tired
or under the influence of drugs, alcohol or medication. A moment of
inattention while operating machines may result in serious personal injury.
b) Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes, hard hat,
or hearing protection used for appropriate conditions will reduce personal
injuries.
c) Prevent unintentional starting. Ensure the switch is in the OFF-posi-
tion before connecting to power source and / or battery pack, picking
up or carrying the machine. Carrying machines with your finger on the
switch or energising machines that have the switch on invites accidents.
d) Remove any adjusting key or wrench before turning the machine on.
A wrench or a key left attached to a rotating part of the machines may result in
personal injury.
e) Do not overreach. Keep proper footing and balance at all times.
This enables better control of the machine in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewellery. Keep your
hair, clothing and gloves away from moving parts.
Loose clothes, jewellery or long hair can be caught in moving parts.
g) If devices are provided for the connection of dust extraction and
collection facilities, ensure these are connected and properly used.
Use of dust collection can reduce dust-related hazards.
h) Do not let familiarity gained from frequent use of machines allow
you to become complacent and ignore machine safety principles.
A careless action can cause severe injury within a fraction of a second.
4) Machine use and care
a) Do not force the machine. Use the correct machine for your appli-
cation. The correct machine will do the job better and safer at the rate for
which it was designed.
b) Do not use the machine if the switch does not turn it on and off.
Any machine that cannot be controlled with the switch is dangerous and must
be repaired.
c) Disconnect the plug from the power source and / or the battery pack
from the machine before making any adjustments, changing acces-
sories, or storing machines. Such preventive safety measures reduce
the risk of starting the machine accidentally.
d) Store idle machines out of the reach of children and do not allow
persons unfamiliar with the machine or these instructions to operate
the machine. Machines are dangerous in the hands of untrained users.
e) Maintain machines. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may affect
the machine's operation. If damaged, have the machine repaired
before use. Many accidents are caused by poorly maintained machines.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
g) Use the machine, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and
the work to be performed. Use of the machine for operations different from
those intended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and
grease. Slippery handles and grasping surfaces do not allow for safe handling
and control of the machine in unexpected situations.
5) Service
Have your machine serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the machine
is maintained.
31.07.23 12:18 31.07.23 12:18