Lionelo Bastiaan i-Size Bedienungsanleitung Seite 11

in such a manner that they cannot be trapped by a sliding seat or vehicle door under
normal vehicle operating conditions.
4.
For rear-facing installation, do not use the seat where the front airbag is active.
5.
Any seat belts that hold the child must be well-fitted to the child's size. The belts
must not be twisted.
6.
The straps securing the restraint to the vehicle must be tight.
7.
Make sure the lap belts run low to adequately secure the pelvis.
8.
If the product has been exposed to strong factors (such as impact), it should be
replaced.
9.
Do not make any changes to the seat or add new components without approval
from the approval authority. To ensure maximum safety for your child, the equipment
should be attached and used as recommended in the instructions.
10. The plastic parts of this seat can heat up in the sun and cause burns on the child's skin.
11. Never leave a child alone in a car seat in a vehicle.
12. Luggage and other similar items should be secured so that in a collision situation
they will not cause any injury.
13. Do not use the seat without its fabric cover.
14. The cover cannot be replaced with an item from another set. It is an integral part of
the set and affects the operation of the restraint.
15. Always have this instruction manual with you.
16. Refer to the vehicle manufacturer's owner's manual.
17. The device may not fit all approved vehicles when adjusted for a range above 135 cm.
PART DESCRIPTION (FIG. B)
1.
Headrest
2.
Shoulder belt guide
3.
Infant reduction insert
4.
Protective cushions for 5-point seat
belts
5.
5-point seat belts
6.
Seat belt buckle
7.
Seat belt tension adjustment strap
8.
Seat tilt adjustment lever
9.
Headrest adjustment lever
10. Lap belt guide
11. ISOFIX arms
12. ISOFIX sliding lever
13. Seat rotation button
14. Seat base
15. Seat belt tension adjustment button
16. Top Tether belt
17. Top Tether belt length adjuster
18. Top Tether belt hook
‑ 11 ‑ EN