Operation - LaserLiner MultiFinder Plus Bedienungsanleitung

1 Insert battery
Open the battery compartment
on the housing's rear side and
insert a 9 V battery. Correct
polarity must be observed.
2

Operation

Switch on: Briefly press the On/Off button (4).
Switch off: Keep the On/Off button (4) pressed for 4 seconds.
AutoShutOff: The device will automatically switch itself off
about 2 minutes after the last measurement.
3 Symbols
Red = Live wire warning
METAL-SCAN and AC-SCAN
mode
Green: metal or live wire is
nearby
Red: metal or live wire found
STUD-SCAN mode
Red: object is nearby
Green: object found
4 Calibration
Auto-Calibration
The automatic calibration is performed in METAL-SCAN
and AC-SCAN measurement immediately when the device
is switched on and when the measuring mode is switched.
Auto-Cal Plus
When an object has been found, the device performs another
automatic calibration in METAL-SCAN measurement. This
simplifies the process of isolating objects to be measured
and adjusting the device to different surfaces.
12
GB
metal, wire, object is
nearby
metal, wire, object
found