HBM C2A/M1 Serie Montageanleitung Seite 25

C2A/M1...
How to use the enclosed grease tube
NOTE
Before fitting the load cell, the enclosed grease must be applied to the
upper thrust piece and to the underside of the pendulum bearing in
order to minimize friction between the inside surface of the thrust piece
and the load introduction element of the C2A load cell or pendulum
bearing.
Use of the spacer plates provided
The scope of delivery of the module includes 2 x 5 spacer plates. They are
used for the vertical adjustment of the module. Five plates max. are to be
fitted underneath the upper module plate, and five plates max. between the
base and the cross bracket of the anti-liftoff device
Ensure that all screws are fitted with U-washers.
Air gap1 mm
5 spacer plates max.
for height adjustment
Fig. 2.1: Fitting of the spacer plates with 5 t version
A2174-1.0 de/en/fr
Upper module plate
Mounting base
5 spacer plates max.
for height adjustment
Bearing
Dummy
Cross-bracket
(Anti-liftoff device)
Lateral stops
25
HBM