EHEIM CLEAR UVC-24 Bedienungsanleitung Seite 16

English
Setting up the UVC lamp
DANGER! UVC lamp contains mercury!
▶ Handle the UVC lamp with care.
▶ DANGER OF BREAKAGE! Do not touch the glass element directly with your fingers. Instead,
always use a soft cloth or similar item.
WARNING! UV radiation!
▶ Never operate the UVC lamp outside the appliance. Unintended use of the appliance or damage to
the housing may result in the emission of dangerous UVC radiation. UVC radiation can cause injury
to eyes and skin, even at low dosage levels.
1. Insert the provided UVC lamp into the pond clarifier.
(see chapter Maintenance - replacing the lamp).
Attaching the UVC clarifier to a solid base (⌦A)
For a secure fitting, you can attach the UVC clarifier to a solid base (e.g. a wooden or metal plate). To do so,
proceed as follows:
1. Drill the corresponding fixing holes.
2. Screw the UVC clarifier onto the wooden or metal plate.
If you want to operate the UVC clarifier without a solid base, you must ensure that the UVC clarifier is
stable on its mounting feet.
Taking the UVC clarifier out of the bail restraint (⌦B)
1. Remove the fastening screws.
2. Take off the mounting bracket.
3. Lift the UVC clarifier out of the mounting feet.
Fitting the hoses (⌦E/F)
1. Use a saw to shorten the connecting piece to the diameter of your hose (⌦C).
2. Place the sealing washer ③ between the screw connection on the housing and connecting piece ②
(⌦D).
3. Screw the connecting piece onto the screw connection with the union nut ①.
4. Connect the hose to the corresponding connecting piece.
We recommend fastening the hoses onto the connecting piece with hose clamps.
Operation
Switch on the UVC clarifier
DANGER! Electric shock!
▶ Place the UVC clarifier at a minimum of 2 m from the pond bank.
CAUTION! Material damage.
▶ Never operate the UVC clarifier without a water flow. The water serves to cool the UVC lamp.
16