Clearing Faults - EHEIM CLEAR UVC-24 Bedienungsanleitung

English
2. Unscrew the lamp holder. Press the unlocking button, rotate the lamp holder in an anti-clockwise
direction and remove the lamp holder from the housing (⌦G).
3. Remove the locking screw (⌦H).
4. Remove the clamping screw and carefully pull the glass bulb out of the lamp holder.
5. Remove the UVC lamp from its packaging. Insert the UVC lamp into the lamp socket (⌦I).
6. Install the UVC clarifier again in reverse order. Then insert the glass bulb carefully into the lamp
holder. With the fingertips, push the sealing ring ⑦ of the glass bulb downwards into the gap
between the glass bulb and lamp holder (⌦J).
▶ When assembling, make sure that the sealing ring ⑤ is installed and the blocker ring ⑥ engages
with the lamp holder's lug (⌦J).
7. Rotate the clamping screw until it stops at the lamp holder's lug (⌦K).
8. Secure the clamping screw with the locking screw.
9. Install the lamp holder again in reverse order. Also push the lamp holder's locking lugs through the
corresponding openings in the housing (⌦L).
10. Rotate the lamp holder in a clockwise direction until it locks into place.

Clearing faults

DANGER! Electric shock!
▶ Before clearing faults, remove the mains plug.
Fault
UVC lamp does not illuminate
Water is not clear
For other faults, please contact EHEIM Service.
Decommissioning
Storing and overwintering
1. Clean the appliance
2. Store the appliance in a frost-proof place.
Disposal
When disposing of the appliance, pay attention to the relevant statutory regulations.
Information on the disposal of electrical and electronic appliances in the European Union: Within the
European Union, disposal of electrically operated appliances is governed by national regulations that
are based on the EU Directive 2012/19/EU on waste electrical and electronic equipment (WEEE). The
appliance may no longer be disposed of with the municipal or household waste. The appliance will be
Possible cause
No mains voltage
Mains plug is not inserted
UVC lamp is defective
Glass bulb is dirty
UVC lamp no longer works
18
Remedy
▶ Check the mains voltage
▶ Check the supply line
▶ Insert the mains plug in the mains
socket
▶ Replace the UVC lamp
▶ Clean the glass bulb
▶ Replace the UVC lamp