Operation - EINHELL SPK7 Originalbetriebsanleitung

Anleitung_Scheitholz_Saegebock_SPK7__ 29.05.13 13:45 Seite 5
1. Safety regulations
Be sure to wear safety gloves and all other
essential safety equipment when working on the
sawing trestle! It is also imperative to follow the
safety instructions issued with the chain saws!
Take care that you do not injure yourself on
sharp corners or edges.
Place the sawing trestle on a level, non-slip
surface.
Do not overload the chain sawing trestle (max.
200 kg, Ø 250 mm).
The wood you want to saw must always rest
securely on the chain sawing trestle (supported
on at least 2 points) and must not be held by your
hand (do not use single-hand chainsaws).
The wood you want to saw is allowed to project
beyond the chain sawing trestle only to the point
where tipping is impossible.
Each time before use, check that all screws are
securely and correctly fastened.
Do not use this sawing trestle any more if a
securing device, adjusting device or any other
part of the sawing trestle becomes damaged.
2. Layout
A. 4 x foot A
B. 4 x foot B
C. 2 x cross strut C
D. 1 x retention bar
E. 4 x claw stop
F. 2 x chain
G. 2 x cover cap with hole for retention bar
H. 14 x cover cap
I. 4 x M6x50 screw + 8 x M6 washer + 4 x M6 nut
J. 12 x M6x40 screw + 24 x M6 washer +
12 x M6 nut
K. 8 x M6x30 screw + 16 x M6 washer + 8 x M6 nut
L. 4x M6x50 screw + 8x M6 washer large + 4x M6
nut
3. Assembly
See the illustrations.

4. Operation

This sawing trestle is designed for cutting round
wood.
Important: Use the chain sawing trestle only on level
ground.
To prevent kick-back, the retention bar D must be
inserted into one of the holes in the cover caps (Fig.
6) after wood is loaded onto the sawing trestle. Cut
the wood between the feet according to the length
required.
Maximum weight per log: 30 kg
Maximum wood length: 1200 mm
Maximum wood diameter: 250 mm
Maximum load capacity: 200 kg (several logs)
Maximum working height: 95 cm
After work is completed, the chain sawing trestle can
be folded down for storage in minimum space. When
folding down, keep your fingers and other body parts
away from the hinges.
5. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info away from the hinges.
6. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
5