Use And Operation - Klarstein 10028325 Bedienungsanleitung

EN
50

USE AND OPERATION

Starting a Program
1. Insert the plug into the socket.
2. Press the program button , the wash program will be changed as follows direction:
Eco > Glass > 90 Min. > Rapid > Intensive > Normal. If a program is selected, the
response light will light.
3. Then press the Start/Pause button, the dishwasher begins to start. When you press
the Pause button to pause during washing, the program light will stop blinking and
the dishwasher will mooing every minute unless you press the Start button to start.
Change the Programme
You can modify the washing program, when the dishwasher just runs for a short time.
Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must be
refilled (see „Loading the Detergent" ).
• Press Start/Pause Button to pause the machine when the door is closed, Press
Button more than three seconds the machine will be in stand by state,
• Then you can change the program to the desired cycle setting.
Note: If you open the door during washing, the machine will pause. When you close
the door and press the Button, the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher:
• One of the program lights on: stand by or pause
• One of the program lights blinking: run