Dimmer Curve; Master Dimmer - Cameo CLMPARCOB1 Bedienungsanleitung

DIMMER CURVE

The operating modes „DIMMER CURVE LED" and „DIMMER CURVE HALOGEN" can be used to determine how the lighting reacts to sudden, large
jumps in DMX dimmer values in DMX mode (DMX value 000 straight to 255 and the other way round). In „LED" mode, the lighting immediately reacts to
the change in value, without delay, and in „HALOGEN" mode it reacts in a manner similar to that of a halogen lamp with a slight delay (pre-glow and afterglow).
Press the MODE button repeatedly until „DIMMER CURVE" appears on the display. As soon as you press ENTER, the cursor appears in the bottom line of the
display. Now the desired mode can be selected using the UP and DOWN buttons. Confirm the input with ENTER.
IR ACTIVE
In „IR ACTIVE" mode, the multi-PAR lighting system can be controlled solely via the included infrared remote control. To control the lighting system in this
mode, press the MODE button repeatedly until „IR ACTIVE" appears on the display. Then press ENTER, the cursor appears in the
bottom line of the display, and select „ON" by using the UP or DOWN buttons. Confirm the input with ENTER.
If you later want to control the system in DMX mode, by footswitch or in a standalone mode, set the „IR ACTIVE" mode to „OFF" again in the same
manner.

MASTER DIMMER

The „MASTER DIMMER" lets you set the basic brightness of the lighting system in the standalone modes. Press the MODE button repeatedly until
„MASTER DIMMER" appears on the display. Then press ENTER. The cursor appears in the bottom line of the display. Use the UP and DOWN buttons
to set the desired basic brightness (00 - 99) and confirm the input with ENTER.
DIMMER
In „DIMMER" mode, each of the four lights can be set to an individual static colour through colour mixing. Press the MODE button repeatedly until
„DIMMER" appears on the display. Then press ENTER and use the UP and DOWN buttons to select the desired light (PANEL) 1 - 4 and confirm with
ENTER. Now the display shows the brightness values of the individual colour LEDS (R = red, G = green, B = blue, and W = white) of the selected
light from 00 to 99. The cursor is in the „R" field in the top line. Now use the UP and DOWN buttons to set the brightness of the red LEDs. Pressing
ENTER confirms the input and moves the cursor ahead to the „G" field for the green colour LEDs. Here, again use the UP and DOWN buttons to set
the brightness to the desired value. The same procedure also applies to the blue (B) LEDs. After confirming the value for the blue LEDs by pressing
ENTER, „DIMMER" appears on the display again and you can select one of the four lights for colour adjustment as described above.
POWER OUT 1/2
The two safety plug Power POWER OUT jacks 1 and 2 can be separately turned on and off using the menu settings. Press the MODE button repea-
tedly until the display shows „POWER OUT 1 - POWER OUT 2". Now press ENTER, the cursor appears in the top line of the display. Now you can use
the UP and DOWN buttons to turn on or off the safety plug mains socket: POWER OUT 1 (ON) or (OFF). After pressing ENTER, the cursor jumps to the
bottom line and you can turn on or off the safety plug mains socket POWER OUT 2 in the same way as described above. Confirm with ENTER.
20