Makita AS001G Betriebsanleitung Seite 21

Removing and installing filter
CAUTION:
After cleaning filter, be sure to
reassemble it in the correct position.
Clean the filter at regular intervals since using a clogged
filter may result in poor suction performance.
1.
Turn the dust cap on the suction inlet at the rear of
the housing counterclockwise to take the dust cap out
of the housing. Two locking tabs on the dust cap can be
disengaged by aligning them with the guide grooves on
the housing.
► Fig.41: 1. Dust cap 2. Locking tabs 3. Suction inlet
4. Guide grooves
2.
Take the circular sponge filter B (black gray) out of
the suction inlet.
► Fig.42: 1. Circular sponge filter B (black gray)
Do not remove the sponge filter A (yellow) placed fur-
ther inside the suction inlet as it needs to be positioned
to protect the motor from any damage.
► Fig.43: 1. Sponge filter A (yellow)
3.
Wipe and shake dust off circular sponge filter B by
hand. Occasionally wash the filter in water, rinse and
dry thoroughly in the shade before use.
► Fig.44
► Fig.45
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the man-
ual, do not attempt to dismantle the machine. Instead, ask Makita Authorized Service Centers, always using Makita
replacement parts for repairs.
State of abnormality
Motor does not run.
Motor stops running after a little use.
The tool does not reach the maxi-
mum air volume.
Abnormal vibration:
stop the tool immediately!
Motor cannot stop:
Remove the battery immediately!
Probable cause (malfunction)
Battery cartridge is not installed.
Battery problem (under voltage)
The drive system does not work
correctly.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
The drive system does not work
correctly.
Electric or electronic malfunction.
21 ENGLISH
NOTICE:
Having washed in water, dry the circu-
lar sponge filter B up before installing. An insuffi-
ciently dried filter may shorten the service life of the
motor.
NOTICE:
Never wash filters in a washing
machine.
NOTICE:
Do not rub or scratch filters with hard
objects such as a brush.
NOTE: Filters wear out in course of time. It is recom-
mended to have some spares for them.
4. Set the circular sponge filter B back over the
suction inlet.
► Fig.46: 1. Circular sponge filter B
5. Reassemble the dust cap onto the suction inlet,
aligning the two locking tabs on the dust cap with the
guide grooves on the housing. Then turn the dust cap
clockwise to secure it in place.
► Fig.47: 1. Dust cap 2. Locking tabs 3. Suction inlet
4. Guide grooves
Remedy
Install the battery cartridge.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Recharge the battery. If recharging is not effective,
replace battery.
Stop using the tool to cool it down.
Install the battery cartridge as described in this
manual.
Recharge the battery. If recharging is not effective,
replace battery.
Ask your local authorized service center for repair.
Ask your local authorized service center for repair.
Remove the battery and ask your local authorized
service center for repair.