HMS BE3200 Bedienungsanleitung Seite 30

A：Power off, loosen the running belt as the method of the belt deviation adjustment, then use a brush to evenly
spread the right amount of silicone oil on the running board, be careful not to apply to ourside of running belt coverage,
and then tighten the running belt.
B：Please do not lubricate excessively, more lubricant is not better. Reasonable lubricate can extend the
treadmill life!
Malfunction treatment
Malfunction
1.No data shown after
power on
2.E01: fault in speed sensor ①Speed sensor is mal or assebmly
3.E02: fault of motor
overcurrent
2.E03: fault
communication
5.E04: fault of driver power
6.'--'displayed in incline
window: fault in incline
detection
7.It runs normally without
load, but it is difficult to start
after load,with pause
Warning: In case of malfunction or damage to the power wire, it must be maintained and replaced by the
professional.
Reasons
①The power wire is not properly pulgged
in
②Overcurrent protector is disconnected
③The transformer is not plugged in
properly or is damaged
④The fuse on the drive is broken
problem come out
②The
optocoupler of driver is broken
③Other peripheral part of controlling IC is
broken
①The motor current is excessive
②The resistance of roller is too high
③The part of driver is broken
①Signal wire is broken
of
②The optocoupler of driver is broken
③The part of the console is broken
①The motor does not plug in properly, or
the motor is broken (circuit open)
②The relay or drive of driver is broken
③The
bridge rectifiers of driver is broken
④Other peripheral part of controlling IC is
broken
①The incline sensor does not plug in
properly
②The incline sensor is broken
③The part of driver is broken
①The torque adjustment of driver is small
②The running belt is too loose。
③There is fault in motor。
Troubleshooting
①Replug the wire。
②Reset the overcurrent protector
③Check or replace transformer
④Replace the fuse
①Check the assembly position or
replace the speed sensor
②Replace the optocounpler
③Replace the driver
①Replace the motor。
②Strengthen the lubricate or
replace
③Replcace the driver
①Check the joint of signal wire
which connects the console and
driver or replace the wire
②Replace the driver or the
optocoupler of driver
③Replace the board of console
①Check or replace the motor
②Replace the relay or the driver
③Replace the bridge rectifieror the
driver
④Replace the driver
①Check connection of the plug
②Replace the incline motor
③Replace the driver
①Adjust the torque potentiometer
on the drive
②Adjust the running belt
③Replace the motor
13