Automatic Programmes - Haier XI6C3D0FB Bedienungsanleitung

"AUTOMATIC" PROGRAMMES
(Only on some models)
Models with Smart Loading Sensor
The "AUTO SENSOR", programme, thanks to an
algorithm that analyses the degree of dirtiness
of the dishes in real time, automatically sets the
ideal temperature and washing time, optimising
water and electricity consumption
Models with dirt sensor
(Only on some models).
The dishwasher is equipped with a dirt sensor,
capable of analysing water murkiness during all
"AUTOMATIC" programme
programme legend). Thanks to this device, the
wash cycle parameters are automatically
adapted to the real quantity of dirt on dishes.
This is because water murkiness is linked to the
quantity of dirt on dishes. Thus, excellent
washing results are guaranteed while optimising
water and energy consumption.
"IMPULSE" PROGRAMMES
(Only on some models)
The "IMPULSE" programmes use an impulse
washing technology,
consumption and
performance.
The "intermittent" working of the washing
pump is NOT to be considered a malfunction;
it is a characteristic of impulse washing, and
therefore should be considered a normal
feature of the programme.
ADDISH (POSSIBILITY OF ADDING
DISHES AFTER THE PROGRAMME HAS
STARTED)
When the programme starts, you should only
open the door and add more dishes when the
ADDISH indicator light is switched on. The
appliance will stop automatically and the time
remaining to the end of the cycle will flash on the
display. Close the door, without pressing any buttons.
Open the door slowly and carefully, to avoid
getting wet with splashes of washing water.
Adding dishes after the ADDISH indicator
light has switched off is strongly discouraged
as this could affect the wash performance.
phases
which reduces
noise, and improves
WARNING
If you open the door during the drying cycle,
an intermittent audio signal advises you that
the drying cycle has not yet finished.
PROGRAMME INTERRUPTION
Opening the door when a programme is running is
not recommended especially during the main wash
and final hot rinse phases. However, if the door is
opened while a programme is running (for example,
to add dishes) the machine stops automatically.
Close the door, without pressing any buttons. The
cycle will start from where it left off.
(see WARNING
If you open the door during the drying cycle,
an intermittent audio signal advises you that
the drying cycle has not yet finished.
CHANGING A RUNNING PROGRAMME.
Proceed as follows to change or cancel a running
program:
Open the door.
•
Keep the START/RESET button pressed for at
•
least 3 seconds. "RESET" will appear on the
display and acoustic signals will be emitted.
Close the door of the appliance.
•
The running programme will be cancelled.
•
At this point a new programme can be set
•
using the " PROGRAMME SELECTION "
button.
WARNING
Before starting a new programme, you should
check that there is still detergent in the
dispenser. If necessary, top up the detergent.
PROGRAMME END
A 5 second buzzer will sound (if not muted) 3
times at 30 second intervals to signal that the
programme has ended.
Only for models with the "OPEN DOOR" option,
during the drying phase the door will open
automatically and you will have to wait until
for the end-of-cycle signal before removing the
dishes.
EN 101