Haier XI6C3D0FB Bedienungsanleitung Seite 103

Turn on the dishwasher by pressing the
•
"ON/OFF" button for about 3 sec.
Select the washing programme.
•
Press the " DELAY START button ("0:30" will
•
appear on the display).
Press the button again to increase the delay
•
(on each press the delay is increased by 30
mins., up to a maximum of 23:30.
When the delay is set on a programme:
•
- after pressing
countdown time "00:00" appears on the
display with flashing " : "
- if you press any button (except for the
"ON/OFF", "PROGRAMME SELECTION"
buttons), the programme name is displayed
for a single scroll on the display and then the
delay time is displayed again.
- When the time has elapsed, the programme
name is displayed for a single scroll on the
display and the remaining time will be
displayed as "0:00h".
To start the
•
START/RESET button. The display will show
the time remaining to the end of the
programme. At the end of the countdown, the
programme will start automatically.
If the delayed start is not confirmed by
pressing the "START/RESET" button, after
approx. 10 sec. the delayed start will be
cancelled.
(Only for free-standing models)
The length of the selected cycle will be shown
on the display. At the end of the countdown,
the programme will automatically start and
the length of the selected cycle will be shown
on the display.
Proceed as follows to cancel a delayed start:
Hold the "START/RESET" button down for at
•
least 3 seconds. "00" will appear on the display
"RESET" and audible signals will sound.
The delayed start
•
programme will be cancelled. Two dashes will
appear on the display.
At this point, to set off the dishwasher, a new
•
programme and any option buttons must be
selected, as indicated in the "PROGRAMME
SETTINGS" paragraph.
"START/RESET",
countdown, press
and the selected
ACTIVATION/MUTED END-OF-PROGRAMME
SIGNAL
You can deactivate turning on and off of the
audio signal as follows (the default setting is
active):
The dishwasher must ALWAYS be off before
you start this procedure.
Open the door.
•
the
Turn on the dishwasher by holding the
•
"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"
•
and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear on the
•
display and the indicator lights of the "OPEN
DOOR/EXPRESS" and "EXTRA DRY" buttons
will be on.
Pressing the "PROGRAMME SELECTION"
•
button until the "BUZZER" parameter is
selected.
Parameter adjustment is performed by
•
the
pressing the "OPEN DOOR/EXPRESS" and
"EXTRA DRY" buttons to change the value
from YES to NO and vice versa.
Switch off the dishwasher by pressing the
•
"ON/OFF" button for 3 secs to confirm the
new setting.
To turn the alarm on again, follow the same
procedure.
MEMO FUNCTION (Memorising the last
programme used)
The dishwasher must ALWAYS be off before
you start this procedure.
Open the door.
•
Turn on the dishwasher by holding the
•
"ON/OFF" button down for about 3 secs.
Hold down the "PROGRAMME SELECTION"
•
and "ON/OFF" buttons for about 5 secs.
The message "SETTINGS" will appear on the
•
display and the indicator lights of the "OPEN
DOOR/EXPRESS" and "EXTRA DRY" buttons
will be on.
Pressing the "PROGRAMME SELECTION"
•
button until the "MEMO
parameter is selected.
Parameter adjustment is performed by
•
pressing the "OPEN DOOR/EXPRESS" and
"EXTRA DRY" buttons to change the value
EN 103
FUNCTION"