A Programme Cannot Be Started - Miele PDW 909 SOM Kurzgebrauchsanweisung

en - Problem solving guide

A programme cannot be started

Problem
The display remains dark,
and the Start/Stop sensor
control does not light up
or flash.
The following appears in
F -Door lock
the display:
fault. You can continue by
pressing the "Start/Stop"
button
The display is dark and the
Start/Stop sensor control
is flashing slowly.
The programme is on the
pre-start screen and the
Start/Stop sensor control
is not flashing.
104
Cause and remedy
No power is being supplied to the washer-dryer stack.
Check whether the washer-dryer stack is switched on.

Check whether the washer-dryer stack is connected to

the power supply.
Check whether the fuse has tripped.

The washer-dryer stack has switched off automatically to
save energy.
Switch the washer-dryer stack back on with the  but-

ton.
The door is not locked properly. The door lock could not
engage.
Close the door again.

Start the programme again.

If the fault message appears again, contact the Cus-
tomer Service Department.
The display has switched off automatically to save energy.
Touch any of the controls. The display switches back on.

The drum door has been pushed to but is not closed cor-
rectly.
Check whether the drum door is closed correctly.
