Herunterladen Diese Seite drucken

HYPE 022-1200 Bedienungsanleitung Seite 5

Werbung

Prüfen Sie nun, ob sich alle Ruder korrekt bewegen. Zu-
erst(!) den Sender einschalten, danach den geladenen An-
triebsakku im Modell anschließen. Betätigen Sie der Reihe
nach alle Funktionen am Sender. Vorsicht im Umgang mit
der drehenden Luftschraube! / Check the function of all
rudders. Switch on the transmitter first(!) and connect then
the LiPo-Battery to the controller in the model. Move all
rudders one by one. Attention! Be careful with the rotating
propeller! / Verificate ora che tutte le parti mobili si muova-
no correttamente: accendere la trasmittente e collegare al
batteria caricata nel modello. Ora provare tutte le funzioni
radio. Attenzione a non ferirvi con l'elica in rotazione!
Beim Ausschalten stets zuerst das Modell und dann den
Sender ausschalten. / Always switch off the model first,
then switch off the transmitter. / Per spegnere spegnete
sempre prima il modello e poi la trasmittente!
Stellen Sie die maximalen Ruderausschläge gemäß der
nachfolgenden Werte ein. / Adjust the maximum travel of
the control flaps according to the sketch below. / regolare
le escursioni massime dei piani mobili come segue:
QUERRUDER
SEITENRUDER
AILERON
RUDDER
ALETTONI
TIMONE
30°
30°
Best.-Nr. / Item-No. / art. 022-1200
HÖHENRUDER
ELEVATOR
PIANO DI QUOTA
35°
16°
16°
35°
45 mm
Abschließend muss der Schwerpunkt am Modell überprüft
werden. Dazu werden alle Komponenten (auch der Akku!)
im Modell montiert. Der Schwerpunkt liegt 45 mm hinter
der Nasenleiste. Unterstützen Sie das Modell mit zwei
Fingern exakt an diesen Punkten und beobachten Sie,
wie das Modell auspendelt. Die Nase des Modells sollte
sich leicht nach unten neigen. Dann ist der Schwerpunkt
optimal justiert. / Before the first flight you have to check
the center of gravity. For doing so you have to mount all
components (also the battery!) in to the model. The CG
is placed 45 mm behind the nose cone of the main wing.
Support the model exactly at the marked spots on the
bottom side of the wing. Put the model on two fingers and
watch the fuselage. The nose should point slightly to the
ground. Then the CG is placed correctly! / Verificare il
centro di gravità. Dovrete usare il modello completo della
batteria! Il CG è a 45 mm dietro il bordo d'entrata dell'ala.
Tenere il modello tra due dita come mostrato e guardate
la fusoliera. Il muso dovrebbe puntare leggermento verso
il basso.
Seite 5

Werbung

loading

Diese Anleitung auch für:

Cessna 182 skylane022-1200 arf