Troubleshooting - SOUNDMASTER ELITELINE ICD2060 Bedienungsanleitung

Error
The device does not
switch on.
Switch automatically off Due to ErP2 requirements and environmental protection, the unit
No sound.
No network connection
can be established.
WiFi connection cannot
be established.
No station is found.
Hiss in FM mode
No stations available /
burbling / intermittent in
DAB mode.
Alarm does not work.

TROUBLESHOOTING

Remedy
Check it the power adaptor is connected properly.
automatically switches to standby mode when no music is played
for more than 15 minutes.
1. Turn on the sound as it may be muted
2. Increase the volume.
3. Pull any connected headphone or speaker from the connector
jack.
1. Check the WLAN function.
2. Try to set an IP address at the device.
3. Activate the DHCP function on the router and make the
connection again at the device.
4. A firewall is activated on the network – set the respective
program in such a way that access is possible.
5. Reboot the router
1. Check the availability of WLAN network on the router.
2. Place the device closer to the router.
3. Make sure the password is correct.
1. Check the network as well as the access point and firewall.
2. The station may not be available currently, try it again later or
select another station.
3. The link of the station is changed or the station no longer
transmits – ask the provider for information.
4. The link of manual added station is not correct, make sure it is
correct and re-enter.
Check/move the FM antenna or move the radio
1. Move the radio.
2. Rescan local stations only (high-strength).
3. Check the local DAB coverage.
1. Switch on the alarm.
2. Due to the volume setting, refer to the solutions of "No sound".
3. The source of alarm was set to be station but there is no network
connection. Change the source of alarm or reconfigure the
connection.
19
ICD2060 / English Instruction Manual