Cd Mode - SOUNDMASTER ELITELINE ICD2060 Bedienungsanleitung

Notice!
Improper operation can result in material damages!
Do not insert any recording media that deviate from the standard CD format (eg: mini-discs) into
the CD player. These may not be played and ejected correctly. Insert only one disc at a time
into the CD player.
1. Press button on the unit and press
or press the "CD" button on remote control to choose CD.
2. Put a disc (with printing side facing up)
functions will not work while the disc is loading. After Reading the display shows the
following information in CD mode:
•

CD mode

•
Time
•
Elapsed playback time in minutes
•
Track number
•
Playback status (playing/pause)
The Playback will begin automatically once the table of contents is read. The display will show
"No Disc" when the unit is set to CD mode and there is no CD inside.
⚫ To pause/resume playback of the CD, press the "
⚫ To switch to the next track, press the "
⚫ To fast forward through a track, press and hold the "
⚫ To switch to the previous track, press the "
⚫ To fast backward through a track, press and hold "
⚫ To stop CD playback, press the "
⚫ To eject the disc press in stop mode the "
CD Program
1. Set the unit in Stop mode
2. Press the "PROGRAM" button on the Remote Control. The display will show "T01 P01"
and "T01" flash.
3. Choose with "
programmed and confirm the track by pressing the "PROGRAM" button on the Remote
Control. The display changes to "P02".
4. To choose more tracks do step 3 again.
5. If all tracks are programmed press the "
programmed playback.
" or " " or 0 to 9 on the Remote Control, the track which should be
CD MODE
till "CD" displayed, then press "OK" on the knob
The display will say "Loading" and the disc
inside.
" button
" button once
" button twice
" button.
" button on the remote control.
" button on the unit.
" button on the unit or Remote Control to start the
16
ICD2060 / English Instruction Manual
" button.