Switching The Unit On/Off - ecofort ecoQ DryAir 20L Complete Gebrauchsanweisung

Operating Instructions
Note:
• Ensure the supplied power is in correspondence with the value on the label.
• Ensure the water tank is correctly fitted, otherwise the dehumidifier cannot be turned
on.
• If the dehumidifier is turned off and then turned back on again immediately, it will
take approximately 3 minutes to reach full dehumidifying power (compressor requires
time to restart).
• If the dehumidifier is switched off by a power cut, it will automatically switch back on
once power is restored.
• The dehumidifier works best at normal room temperature, its efficiency is reduced if
the ambient temperature drops below 15 °C.

Switching the Unit On/Off

Connect the mains lead to socket.
Press Power button once to turn on the unit. By default, it runs in Manual Dehumidifying
Mode. Press Power button once again to turn off the unit.
Humidity Setting
Press Manual button once to enter Manual Dehumidifying Mode or to select desired level of
humidity from CO-30%-35%-40%-45%-50%-55%-60%-65%-70%-75%-80%-CO.
Note:
• If ambient humidity is lower than 30%, display shows LO.
• If ambient humidity is higher than 90%, display shows HI.
• In the ecofort SMART App CO will be displayed as 25%
80 | Instruction Manual ecoQ DryAir 20L & 25L Complete