To Change The Status Of A Direct Function - Daikin LMS Serie Betriebsanleitung

3 Press a button (e.g. the continuous cycle button).
Result: The status changes (e.g. from active to not active).
4.2.7

To change the status of a direct function

INFORMATION
If no button is pressed, after 20 seconds the terminal will
automatically return to the standard display.
1 Unlock the user interface. See "4.2.1 To unlock the user
interface" [ 4 7].
2 Press the PROGRAM button to enter "dir" mode.
Result: The display shows "dir".
Changing the direct function:
3 Press the PROGRAM button in the "dir" screen.
Result: The display shows the first direct function screen (e.g.
"Fr").
4 Press the UP and DOWN buttons to navigate the menu.
5 Press the "PRG" button when arrived at the direct function
screen you want to change (e.g. "Eco").
Result: You entered the direct function.
6 Press the UP and DOWN buttons to change the setting (e.g.
change to "On").
LMSEY1A09/13 + LMSEY2A19/25
Daikin LMS
4P728169-1B – 2023.07
7 Press the PROGRAM button to confirm the new setting.
Result: The display goes back to the direct function screen
(e.g. "Eco").
8 Press the UP and DOWN buttons to navigate the menu. Scroll
to the next direct function of which you want to change the
status.
When finished changing direct functions status:
9 Scroll to the "ESC" screen.
10 Press the PROGRAM button.
Result: The display goes back to the actuator/function direct
("dir") activation screen.
Meaning of direct function screens that appear on the display
Display Description
Alr Display alarms
Auc Activate auxiliary output
BtE Enable Bluetooth
CnC Activate continuous cycle
dfM Start defrost
Ec1 Load embedded
configuration 1
Ec2 Load embedded
configuration 2
Eco Activate ECO mode
Fr Firmware version
HAC Direct access to HACCP
menu
HL Dim Light
HU Set humidity level
Lht Activate lights
nFE Enable NFC memory
reading
OnF Unit On/Off
Pd Activate pull down
rH Maximum value of control
probe
rL Minimum value of control
probe
rtL Reset min/max control
probe
SAh Display alarm log
Sc Condenser probe
Sc1 Quick Set point 1
Sc2 Quick Set point 2
Sc3 Quick Set point 3
Sd Defrost probe
SHu Humidity probe
Sm Outlet probe
SPr Product probe
SrG Control probe
St Set control set point
StH Set humidity set point
4 User interface
Display alarms
DOC > 0
If featured
cc > 0
If featured
If featured
/AF > 0
F2 = 3
DOE > 0
rM = 1
rM = 1
rM = 1
/Fo > 0
/Fb > 0
/FP > 0
/Fa > 0
/FR > 0
/SP > 0
Operation manual
9