Configuration; To Connect Your Device With Daikin User; To Change The Parameters - Daikin LMS Serie Betriebsanleitung

4 User interface
4.3

Configuration

4.3.1

To connect your device with Daikin User

INFORMATION
Setting parameters is best done via the app (Daikin User
or Daikin Installer). However, some of the parameters can
also be set via the user interface.
The Daikin User app is required to configure the controller, set up
parameters or check trends and information.
From a mobile device (smartphone, tablet), via BLE (Bluetooth Low
Energy), the Daikin User app can configure the commissioning
parameters and set groups of preset parameters according to
specific needs (configurations).
Use the "hamburger" menu at the top left of the screen to set the
parameters on the controller and manage parameter configurations.
Procedure to install the app:
1 Download the "Daikin User" app.
2 On the mobile device, start the app for commissioning the
controller.
3 Turn on Bluetooth on your device. Open Daikin User and select
the Bluetooth icon to show the available devices.
4 Select "BLUETOOTH SCAN" to view the controller devices
available within a range of 10 m.
5 Select the device to connect to.
Result: "BLE" will blink on the user interface display to confirm that
the connection is established.
INFORMATION
During the first connection, the app (Daikin User or Daikin
Installer) synchronises with the controller software via a
cloud connection. This means that an internet connection
is required, at least for this first connection. If not, the
required packet can also be retrieved from the cloud as
soon as the connection is restored (via the "Packet
Manager" section of the app).
Operation manual
10
BLE
4.3.2

To change the parameters

1 Unlock the user interface. See "4.2.1 To unlock the user
interface" [ 4 7].
2 Press the PROGRAM button to enter "dir" mode.
Result: The display shows "dir".
3 Use the UP (a) and DOWN (b) buttons to navigate towards the
desired menu, then press the PROGRAM (c) button to enter the
menu.
a UP button
b DOWN button
c PROGRAM button
CtL Control menu
Pro Display probes menu
HcP HACCP menu
CnF Configuration menu
ALM Alarms menu
PSd Service menu
ESC Exit the menu loop
Note: To return to the standard display, go to "ESC" and press the
PROGRAM (c) button.
INFORMATION
If no button is pressed, the terminal will return to the
standard display after 7 seconds.
a b c
LMSEY1A09/13 + LMSEY2A19/25
Daikin LMS
4P728169-1B – 2023.07