Changing The Filter; Cleaning The Motor Unit Housing - Beurer LB 200 Gebrauchsanweisung

8.3 Changing the filter

NOTICE
When replacing the filter
and replacement parts").
Change the filter after 6 months at the latest. After 1440 operating hours*, the filter change indicator
4
lights up automatically. If the filter
operating hours have elapsed, you must replace the filter
counter to 0 (see step 6 in this section).
1. Disconnect the air humidifier
from the socket.
4. Place the new filter on the filter
holder . Make sure that the
7
round hole of the filter holder
is on the small projection in
7
the bottom of the water tank.
* Based on an average of 8 hours of daily use of the air humidifier over 6 months.

8.4 Cleaning the motor unit housing

Clean the housing of the motor unit
use solvents, other aggressive cleaning/scrubbing agents or alcohol, as these could damage the surface.
 WARNING
Never clean the motor unit
, only use original replacement filters from Beurer (see section "9. Accessories
4
is already heavily soiled, deformed or discoloured before the 1440
4
2. Pull off the motor unit
upwards.
5. Put the motor unit
the water tank
that there is no gap between
them.
with a slightly damp cloth (water or a mild cleaning solution). Do not
3
in the dishwasher. Make sure that no liquid enters the air outlet
3
earlier and then reset the operating hours
4
3. Remove the old filter
3
6. Switch on the air humid-
back on
3
. Make sure
8
27
dispose of it properly.
ifier using the ON/OFF
button . Press and hold the
10
timer button for 5 seconds
14
until the filter change indicator
goes out. Internal operating
19
hours counter is now reset to 0.
19
and
4
.
2