Timer Function; Cleaning And Maintenance; Filter Drying Function; Cleaning The Filter - Beurer LB 200 Gebrauchsanweisung

2
Medium fan speed
3
High fan speed
SL
In NIGHT mode all displays on the control panel
cator
A
In AUTO mode, the fan speed is automatically adjusted depending on how close the
current humidity is to the desired target humidity.

7.4 Timer function

The air humidifier features a timer function that you can use to determine the number of hours the air
humidifier should run for before it automatically switches itself off. You can set a timer for between 1 and
9 hours.
1. Use the timer button
(e. g. 5 h). After a few seconds, the current air humidity is shown again on the display
2. To switch off the timer, press the timer button
is now switched off.

8. CLEANING AND MAINTENANCE

8.1 Filter drying function

Mould and bacteria can form in the filter
the residual water from the tank and dry all parts when the device is not in use. Allow the filter
or use the filter drying function for faster drying:
1. Before activating the filter drying function, ensure that the residual water has been emptied from the
tank (residual moisture may collect under the filter holder
drying function can only be started once the residual water has been emptied.
2. To activate the filter drying function, press and hold the fan speed button
drying indicator
18
setting for the next 3 hours. To switch off the filter drying function prematurely, press any other button.
3. After the time has elapsed, check that the filter
activate the filter drying function again.

8.2 Cleaning the filter

 WARNING
Before cleaning, always ensure that the mains plug of the air humidifier has been properly
disconnected. Only clean the filter
tions for use. Never clean the filter
Regular cleaning of the filter
weekly under running water to remove dust, dirt and hair.
NOTICE
Replace the filter
4
calcified, descale it as described in section "8.6 Descaling".
. In NIGHT mode, the low fan speed is always active.
16
to select your desired timer. The currently set timer lights up on the display
14
4
will start to light up. The filter drying function now dries the filter
4
4
is required to ensure hygienic and fault-free operation. Rinse the filter
4
after 6 months at the latest (see section "8.3 Changing the filter"). If the filter
repeatedly until 0 h is shown in the display. The timer
14
when the air humidifier is not in use. Therefore, always empty
, which must be dried manually). The filter
7
is completely dry. If the filter
4
according to the method described in these instruc-
in a washing machine or dishwasher.
26
go out, except for the NIGHT indi-
1
for 5 seconds. The filter
15
is not completely dry,
4
1
.
11
to air dry
4
at the highest
4
4
is
4