Setting Target Humidity; Setting The Fan Speed/Mode - Beurer LB 200 Gebrauchsanweisung

Step 6: After use
1. Disconnect the mains plug from the socket after each use.
2. Empty any remaining water from the water tank
in the water tank
3. Allow the filter
4
function from time to time after use (see section "8.1 Filter drying
function").
If you want to reposition the air humidifier, pull the mains plug
out of the socket and empty the water tank
flowing. When carrying the air humidifier, make sure that you
hold the device with both hands at the bottom of the water
tank .
8

7.2 Setting target humidity

If desired, you can optionally set a target air humidity on the air humidifier.
The target humidity indicator
If no value lights up in the target humidity indicator
70 % is reached and then switches off. In order to avoid overhumidification of a room, we recommend that
you select a humidity between 40–60 %.
1. Use the target humidity button
2. The selected target humidity will light up in the target humidity indicator
target humidity indicator
the air humidifier switches off automatically.
In order to achieve the desired target air humidity as quickly as possible, we recommend
keeping the windows and doors closed during use, as dry outside air could slow down
reaching the target air humidity.

7.3 Setting the fan speed/mode

The air humidifier has three fan speeds ( I, 2 and 3 ) and two modes ( AUTO mode A
SL
).
• With the air humidifier turned on, use the fan speed button
display shows the currently set fan speed or current mode. After a few seconds, the current relative
11
humidity of the room is shown again on the display
Illumi-
nates in Description
display
I
Low fan speed
when the device is not in use.
8
to air dry when not in use or use the filter drying
shows the currently set target humidity (40 %, 50 % or 60 %).
12
to select your desired target humidity.
13
, the target humidity is set to 70 %. As soon as the target humidity is reached,
12
. Do not leave water
8
to avoid over-
8
, the humidifier humidifies the air until a humidity of
12
to select a fan speed or mode. The
15
.
11
25
. If no value lights up in the
12
and NIGHT mode