Application Methods - Beurer IPL 7800 Cool Pro Gebrauchsanweisung

7.1 Application methods

 WARNING
Do not treat the same area twice within one treatment. The risk of side effects is increased
if an area is treated more than once.
The pulses from the device should be applied in rows – beginning at one
end of each row, continuing to the other end. This technique allows better
monitoring of the areas of skin that have already been treated and helps you
to avoid treating the same area more than once or treating overlapping areas
of skin.
Application method 1: "Auto Flash" mode
Ensure that the skin contact sensor
hold the trigger button
regular intervals and the "Auto Flash" indicator lamp
does not require the trigger button
be ended by briefly pressing the trigger button
treating large areas in particular, for example the legs.
Application method 2: Triggering individual flashes
Release the trigger button
device on the area directly next to the area that has just been treated. Ensure that the
light area and skin contact sensor
1
guarantees precise treatment, e.g. for knees or ankles.
If the device does not emit any light pulses and the skin contact indicator
lamp
5
making sufficient contact with the skin.
Allow the device to cool for a few minutes if it seems too hot for you. You can
continue your treatment as normal after a short cooling period.
2
for two seconds. The device automatically emits light pulses at
6
6
after each light pulse. For the next light pulse, position the
6
does not light up, this means that the skin contact sensor
is making sufficient contact with the skin. Press and
4
to be pressed manually. The "Auto Flash" mode can
. The "Auto Flash" mode is suitable for
6
come into full contact with the skin. This mode
2
37
lights up permanently. This mode
is not
2