Application Methods - Beurer SatinSkin Pro IPL6500 Gebrauchsanweisung

2. Press the ON/OFF/power selection button. On the intensity display,
a small light (level 1) begins to illuminate continuously in green.
3. If you wish to carry out an application at a higher intensity level,
increase the intensity by repeatedly pressing the ON/OFF/power
selection button until you have reached the desired intensity.
4. Position the light area on the skin and press the trigger button in
order to release a light pulse. Ensure that the light area and skin
contact sensor come into full contact with the skin. A light pulse
can only be released once the skin contact sensor is in full contact
with the skin. You will see a bright flash, hear a cracking noise and
may feel a slight burning sensation and/or warmth. The device fan
switches on after the first flash. Within 1.3-3.5 seconds (depending
on the intensity level), the device is ready for the next pulse and the
indicator lamp on the device is continuously illuminated green..

6.1 Application methods

WARNING
Do not treat the same area twice within one treatment. The risk of side effects is increased
if an area is treated more than once.
Note
The pulses from the device should be applied in rows – beginning at one end of each row,
continuing to the other end. This technique allows better monitoring of the areas of skin that
have already been treated and helps you to avoid treating the same area more than once
or treating overlapping areas of skin. The light area of the device is designed in such a way
that it leaves a temporary impression on the treated area of skin. These visible impressions
can be used for precise placement of the next pulse.
Application method 1 "flash-glide function":
Hold down the trigger button. The device emits a series of consecu-
tive light pulses so long as the skin contact sensor is in full contact
with the skin. Move the device onto the next area after each light
pulse. Continue to hold the light area down on the skin. This mode
is suitable for treating larger areas in particular, for example the legs.
Application method 2 "releasing individual flashes":
Release the trigger button after each light pulse. For the next light pulse, position the device
on the area directly next to the area that has just been treated. Ensure that the light area
and skin contact sensor come into full contact with the skin. This mode guarantees precise
treatment, e.g. for knees or ankles.
35