Sony VPL-SW525C Kurzreferenz Seite 54

Performing Calibration (Position
alignment)
Use the supplied USB cable to connect the
projector to the computer. Click the icon in
the taskbar to display the pop-up menu, then
select [Calibrate].
Minimize
Save setting
Calibrate
Information
Exit
[Calibrate] appears in the pop-up menu
when your computer is connected to the
projector.
Calibration is the operation to align the pen
position on the projection surface with the
mouse position on the computer screen. Be
sure to perform calibration when using the
Interactive function for the first time.
Changing resolution or moving the projector
may offset the current calibration. In this
case, perform calibration again.
Calibration (Position alignment)
A flashing dot appears in the top left of the
screen.
Touch the center of the dot with the tip of the
Interactive Pen Device until the dot stops
flashing.
The dots appears from the top left to bottom
right of the screen. Repeat the above for all
dot positions to complete calibration.
20
GB
Using the Interactive Function
Note
Make sure you touch the center of the dot,
otherwise positioning may be offset.
Operating with the Interactive Pen
Device
With the Interactive Pen Device, you can use
the functions of the toolbar on the screen.
See "Toolbar" for details.
Closing Interactive Presentation
Utility
Click the icon in the taskbar to display the
pop-up menu, then select [Exit].