Sony VPL-SW525C Kurzreferenz Seite 49

Correcting trapezoidal distortion of the projected image (Keystone feature)
If the image becomes trapezoidal, set the keystone manually.
1 Press the KEYSTONE key on the remote
commander or select V Keystone in the
Installation menu.
2 Use the V/v/B/b keys to set the value. The
higher the value, narrower the top of the
projected image. The lower the value, the
narrower the bottom.
Notes
• Since the Keystone adjustment is an
electronic correction, the image may be
deteriorated.
• Depending on the position adjusted with the
lens shift feature, the aspect ratio of the
image may change from the original or
projected image may be distorted with
Keystone adjustment.
Displaying a pattern for adjusting an image
You can display a pattern for adjusting the projected image with the PATTERN key on the
remote commander. Press the PATTERN key again to restore the previous image.
Automatically adjusts Phase, Pitch and Shift of projected image while a
signal is input from a computer (APA (Auto Pixel Alignment))
Press the APA key on the remote commander. Press again to cancel adjusting during the setting.
You can also set APA in the Screen Menu. If Smart APA in the Function menu is set to "On",
executes APA automatically when a signal is input.
Shrinking an image that exceeds the screen size
1 Select "Digital Shrink" in "Screen Fitting" to display adjusting menu.
2 Adjust the value by the V/v/B/b keys. The higher the value, the smaller the image becomes.
Note
Since the Digital shrink is an electronic correction, the image may be deteriorated.
Increase the number
towards plus
Increase the number
towards minus
Projecting an Image
15
GB